Sony STR-DA3700ES, Руководство по эксплуатации

Страница: 129 / 146

129 US
Ad
d
ition
al In
fo
rm
atio
n
• Set “Auto Standby” to “Off” (page 107).
While only composite video signals are
being recorded, the auto standby function
of the receiver may start up and interrupt
the recording.
Specific type of image is not output or
corrupted.
Component video output
• The resolution of output signals from the
COMPONENT VIDEO OUT jacks may
not be supported by your TV. In this case,
select the appropriate resolution on the
receiver (page 100).
• COMPONENT VIDEO MONITOR OUT
jacks have restrictions on resolution when
the resolution of video signals protected
by copyright technology is converted. The
resolution of the signals output to the
COMPONENT VIDEO MONITOR OUT
jacks is converted up to 480p/576p.
HDMI output
• Be sure to use a connecting cable for the
HDMI jack corresponding to High Speed
HDMI cable when you view images or
listen to sound, especially for the 1080p,
Deep Color, or 3D transmission.
3D image
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the 3D image formats
supported by the receiver (page 139).
VCR
• If you use a VCR without an image
improvement circuit, such as TBC, the
images may be distorted.
When you select “My Video,” “My
Music,” “My Photo,” “Internet Video,”
“Internet Music,” “Internet Photo,”
“Internet Network,” or “Sony
Entertainment Network” from the
Watch/Listen menu, no picture is
output.
• Select “BD/DVD” using INPUT
SELECTOR on the receiver once, then set
“Playback Resolution” to “480p/576p” in
the Video Settings menu using the GUI
(page 101), and select the content again.
There is no sound, no matter which
equipment is selected, or only a very
low-level sound is heard.
• Check that the speakers and equipment are
connected correctly.
• Check that both the receiver and all
equipment are turned on.
• Check that MASTER VOLUME control is
not set at –
∞
dB. Try to set it at about
–40 dB.
• Check that SPEAKERS (A/B/A+B/OFF)
is not set to OFF (page 10).
• Press MUTING on the remote control to
cancel the muting function.
• Try pressing the input button on the remote
control or INPUT SELECTOR on the
receiver to select the equipment of your
choice.
• Check that headphones are not connected.
• When you want to listen to the sound from
the TV speaker, set “Audio Out” to
“TV+AMP” in the HDMI Settings menu.
If set to “AMP,” the sound is not output
through the TV speaker. If you output the
multi-channel sound from the receiver, set
to “AMP.”
• Sound may be interrupted when the
sampling frequency, the number of
channels or audio format of audio output
signals from the playback equipment is
switched.
• Set the “EQ” setting of the iPhone/iPod to
“Off” or “Flat.”
There is severe hum or noise.
• Check that the speakers and equipment are
connected correctly.
• Check that the connecting cords are away
from a transformer or motor, and at least
3 meters away from a TV set or
fluorescent light.
Audio
continued