32
Chapter 3 Installation
3.11.2. Turn Off the Power
Press the power switch on the rear of the AIT autoloader to turn it off.
Caution
Do not turn off the AIT autoloader when it is in use or there is a cartridge in the
AIT drive, as this could damage data.
Note
After turning the AIT autoloader off, wait at least 10 seconds before turning it
on again.
3.12. Setting Cartridges
Prepare cartridges and insert them into the AIT autoloader.
3.12.1. Preparing Cartridges
Make sure that cartridges are not write-protected and prepare them for use.
Verify whether the write-protected tab is in the write-enable position. If the tab
is orange, data can be written to a cartridge.
If the tab is lowered, data can be
written to and erased from the
cartridge.
j
If the tab is raised, data cannot be
written to or accidentally erased
from the cartridge.
J
AIT-1
AIT-2, AIT-3
Lid
If the tab is moved to the left, data
can be written to and erased from
the cartridge.
K
If the tab is moved to the right, data
cannot be written or accidentally
erased from the cartridge.
k
Lid
