59
Chapter 4 Operating the AIT Library
Moving the Cartridges
It is possible to move a cartridge from a slot to the AIT drive or vice versa. Set
the cartridge in the slot before performing the procedure below. When moving
a cartridge, specify the slot with the element address. For information about
element addresses, refer to “Assigned Element Addresses” (page 48) in Chapter
3, “Basic Usage”.
Notes
• It is not possible to move a cartridge between slots. When you want to set a
cartridge in a different slot, first remove the cartridge, then set it in a different
slot.
• It is not possible to remove a cartridge directly from the AIT drive. Perform
the procedure below, move the cartridge to the desired slot, and then remove
it.
1
At the status display, press the [MENU] button for two seconds.
2
Use the
V
and
v
buttons to select “3.Move Tape”, then press the [ENTER]
button.
3
Use the
V
and
v
buttons to set the
element address of the slot that has
the moving source cartridge, then
press the [ENTER] button.
Note
“DR” indicates an AIT drive.
4
Use the
V
and
v
buttons to set the element address of the destination slot,
then press the [ENTER] button.
5
When “[ENTER] to activate”
appears, press the [ENTER] button.
The cartridge moves to a new slot,
and the display returns to the menu.
6
Press the [CANCEL] button to return to the status display.
Viewing Information Related to the AIT Library
Using the Information Menu of the control panel, the following information
related to the AIT library can be viewed:
• Vendor ID
• Product name
• Serial number
• Version
Note
Information related to the AIT library can also be viewed through a browser.
Source DR
Destination 01
Source DR
Destination 01
[ENTER] to activate
