29
Chapter 2 Installation
10
When “[ENTER] to activate” appears, press the [ENTER] button.
If you selected “1. Single Mode” in
step 4, the display on the right
appears.
If you selected “2. Multiple Mode”
in step 4, the display on the right
appears.
The shutter closes and the
initialization is performed.
11
When the initialization ends, press the [CANCEL] button three times to
return to the status display.
Connecting to the Network
If the AIT library is connected to the network, a browser can be used to
configure the library and view status information.
Connect the AIT library to the network as follows.
1
Setup the network.
2
Connect a network cable.
3
Restart the library.
4
Access the library from a browser.
Notes
• For information about how to use the browser to configure individual settings
and view status information, refer to Chapter 6, “Library Administration
Menu” (page 67).
• In order to configure and maintain the library through a browser, browser
software must be installed in the computer. The following operating systems
and browsers are compatible with the library.
Operating systems:
- Microsoft Windows 95, Microsoft Windows 98, Microsoft Windows Me,
and Microsoft Windows 2000
Browsers:
- Microsoft Internet Explorer 5.01 or later
- Netscape Communicator 4.7 or later
Setting the Network
In order to connect to the network, use the Network Menu of the control panel
to configure the necessary settings, such as the IP address setting.
Slot 01
Exit ?
[ENTER] to activate
Insert Tape Slot 01
Exit ?
[ENTER] to activate
Slot 01
Initializing
