SS-HA1/HA3
Connection/Raccordement/Conexión
Speaker cord (supplied)
Cordon d’enceinte (fourni)
Cable del altavoz (suministrado)
Speaker cord (supplied)
Cordon d’enceinte (fourni)
Cable del altavoz (suministrado)
ˎ
ˎ
Output power of your receiver or amplifier must not be over the maximum input power of
the speaker system, and an appropriate volume level to prevent sound distortion must be
kept. See “Specifications” for the maximum input power.
ˎ
ˎ
La puissance de sortie de votre récepteur ou de votre amplificateur ne pas doit être
supérieure à la puissance d’entrée maximum du système d’enceintes, et vous devez
maintenir le volume à un niveau approprié afin d’éviter la distorsion. Voir la section
« Spécifications » pour connaître la puissance d’entrée maximum.
ˎ
ˎ
La potencia de salida del receptor o el amplificador no debe sobrepasar la potencia
máxima de entrada del sistema de altavoces, por lo que, para evitar la distorsión del
sonido, se debe ajustar un volumen apropiado. Puede consultar la potencia máxima de
entrada en “Especificaciones”.
Right
Droit
Derecho
+ terminal (red)
Borne + (rouge)
Te (rojo)
– terminal (black)
Borne – (noire)
Terminal – (negro)
Amplifier
Amplificateur
Amplificador
Left
Gauche
Izquierdo
© 2013 Sony Corporation
Printed in China
English
Owner’s Record
The model and serial numbers are located on the
bottom of the unit. Record the serial numbers in the
space provided below. Refer to them whenever you
call upon your Sony dealer regarding this product.
Model No.
Serial No.
Features
The forward-facing and upward-facing super
tweeter configuration achieves a
multidirectional listening experience. Uniquely
shaped front panels with boldly cut edges
also help prevent sound diffraction. That way,
high-quality sound from sound sources or
CDs can be enjoyed in wider area than with
conventional speakers.
Connections
ˎ
ˎ
Before connecting, turn off the amplifier to
avoid damaging the speaker system.
ˎ
ˎ
When turning the amplifier or program
source power on/off, reduce the sound level
on the amplifier to minimum.
ˎ
ˎ
When bass sound is missing or the sound
output position of musical instruments is
not distinct, make sure the +/– terminals of
speaker cords are connected properly.
Precautions
ˎ
ˎ
Avoid driving the speaker system
continuously with a wattage exceeding the
maximum input power of each speaker.
ˎ
ˎ
Do not place anything on the speakers.
ˎ
ˎ
Do not attempt to open the enclosure or
remove speaker units. There are no
user-serviceable parts inside.
ˎ
ˎ
Keep recorded tapes, watches, personal
credit cards, and hard disk drives using
magnetic coding away from the speaker
system.
ˎ
ˎ
The speaker system has been tuned without
the grill on. Remove the grill before using
the speaker system.
Cleaning and maintenance
ˎ
ˎ
To avoid damaging the enclosure, do not
use thinner, alcohol, benzene, etc.
ˎ
ˎ
To keep a good gloss on the enclosure, dust
it first using a soft cloth, a brush, or a feather
duster and then polish it using a dry
cleaning cloth (never use a scrubbing brush
or a sponge).
ˎ
ˎ
Wipe the surface gently. For fingerprints or
oil stains, etc., breathe on the surface and
wipe it off with a cleaning cloth.
ˎ
ˎ
If the enclosure becomes extremely dirty,
wipe the enclosure using a soft cloth slightly
moistened with a soap and water mix.
ˎ
ˎ
Be careful not to scratch the surface of the
enclosure.
ˎ
ˎ
Wipe dust and other dirt from the super
tweeter (top panel) using a blower brush or
soft brush.
Speaker Placement
ˎ
ˎ
Please note that room acoustics can often
produce large difference in the sound for
small changes in speaker placement.
ˎ
ē
Place the speaker system against a hard
wall with its back about 20 cm away from
a wall.
ˎ
ē
Place the right and left speakers in a
similar acoustic environment.
ˎ
ˎ
Do not place the speaker system in the
following places:
ˎ
ē
Anywhere that is extremely hot or under
direct sunlight
Speaker System
Operating Instructions
Mode d’emploi
Manual de instrucciones
4-475-026-
11
(3)
ˎ
ē
Anywhere that is dusty
ˎ
ē
Anywhere that is extremely humid
ˎ
ē
Near a player
ˎ
ē
In a cabinet, especially one above your line
of sight
Specifications
SS-HA1
Speaker system
3 way, 4 drivers speaker
system
Loud speaker units
Woofer: 13 cm (5 3/4 in.),
cone type (1)
Tweeter: 2.5 cm (1 in.), soft
dome type (1)
Super tweeter: 1.9 cm
(3/4 in.), soft dome type (2)
Enclosure type
Bass reflex
Rated impedance
4 ohms
Maximum input power 100 watts
Sensitivity level
86 dB (2.83 V, 1 m)
Effective Frequency Range 48 Hz - 50 kHz
Dimensions (w/h/d)
Approx. 185 mm × 312 mm ×
312 mm
(7 3/8 in. × 12 3/8 in. × 12 3/8 in.)
Mass
Approx. 4.8 kg (10 lb. 9 oz.)
Supplied accessories
Speaker cords (2)
Operating Instructions (1)
SS-HA3
Speaker system
2 way, 3 drivers speaker
system
Loud speaker units
Woofer: 10 cm (4 in.), cone
type (1)
Super tweeter: 1.9 cm
(3/4 in.), soft dome type (2)
Enclosure type
Bass reflex
Rated impedance
4 ohms
Maximum input power 70 watts
Sensitivity level
83 dB (2.83 V, 1 m)
Frequency range
55 Hz - 50 kHz
Dimensions (w/h/d)
Approx. 150 mm × 231 mm ×
232 mm
(6 in. × 9 1/8 in. × 9 1/8 in.)
Mass
Approx. 3.1 kg (6 lb. 13 oz.)
Supplied accessories
Speaker cords (2)
Operating Instructions (1)
Design and specifications are subject to change
without notice.
