Sony SRX-T420, Руководство по эксплуатации

Страница: 56 / 75

56
Connecting the Projector
Chap
te
r 2
Pr
epa
ra
tio
n
s
Connecting the Projector
When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may
increase noise and reduce performance of picture
signals. When pulling out a cable, be sure to pull it out
from the plug, not the cable itself.
• When installing the optional input board, consult your
Sony dealer.
• For connecting the cable to the connector inside the
projector, consult your Sony dealer.
Refer also to the instruction manuals of the equipment to
be connected.
Connecting a Computer Equipped
with a DVI-D Connector
Connect a computer with a DVI-D connector to the
optional LKRI-005 HDCP DVI input board attached to
any of INPUT A to INPUT D inside the projector.
HDCP (High-bandwidth Digital Content Protection) DVI-
D signal can also be input when the input signal with
specified resolution is input from LKRI-005.
For details, refer to the Operating Instructions of LKRI-
005.
• According to the input signal type, set “Signal Mode” on
“Input Source” in the PICTURE CONTROL window of
the SRX Controller. (page 62)
• When an extension cable is used, the signal may not be
input correctly due to signal reduction.
• If you input 10-bit signals from a DVI-D connector only
(10-bit single mode), a DVI cable compatible with the
Dual-link is required.
Connecting an HD-SDI Equipment
Attach the optional LKRI-003 HD-SDI input board inside
the projector and connect an HD-SDI equipment to the
connectors on the attached input board.
When the LKRI-003 is attached to the projector, select the
type of signal with “Signal Mode” of “Input Source” in the
DVI-D connector AUX connector
DVI cable
(not supplied)
Computer
Notes
Note
HD-SDI connecting cable
(not supplied)
HD-SDI equipment, etc.
to HD-SDI output