14
Starting the Projector
Caution
The projector is not lit if a chiller is not working in a
prescribed condition. Start a chiller in advance.
When using a Sony-recommended chiller that is
communicating with the projector, set the chiller to
standby.
1
In the [Status] tab, tap [Auditorium], and then tap
[Projector] in the [Control] pane.
The “Projector Control” screen will be displayed.
2
Tap [Power On] in [Power/Light].
The MAIN indicator on the rear of the projector will
turn solid green, and the LIGHT indicator will blink
green.
When the projector turns on, its MAIN, LIGHT, and
IMB indicators will be solid green.
3
Tap [CLOSE] at the bottom of the screen to close the
“Projector Control” screen.
The above procedures complete preparations and
confirmation for using the projection system.
Rebooting the System
1
Tap
on the upper right of the screen.
2
Select [Reboot], and then tap [OK].
3
Tap [OK] when the confirmation screen appears.
The server (including the IMB) reboots.
Tips
• The projector itself will not reboot.
• If the projector is lit, it will be turned off, and
entered the cooling state.