Sony SRG-H40UH, Руководство по эксплуатации, Страница: 25 / 54

25
Storing the Camera Settings
in Memory
– Preset Feature
Settings, including the camera position, zoom,
focus, and backlighting, can be stored in a
preset.
Notes
The camera supports up to 100 presets. The
number of presets that are supported will vary
depending on the device used.
– For the RM-IP500 (sold separately), up to 100.
– For the RM-IP10 (sold separately), up to 16.
– For the remote commander (supplied), up to 6.
For details on the camera settings that can be
preset, see “Items Stored in the Preset”
(page 47).
Storing the camera status
1
Press the PAN-TILT RESET button to reset the
pan/ tilt position.
2
Adjust the position, zoom (See page 24),
and focus of the camera (See page 24).
3
Hold down the PRESET button and press
any of the POSITION buttons, 1 to 6, in
which you want to store the settings.
Note
Before you store the position, zoom, focus, etc.
of the camera, make sure to install and secure
the camera in place to use it properly.
Recalling the stored status
Press any of the POSITION 1 to 6 buttons in which
you have stored the settings.
Clearing the preset memory
Hold down the RESET button and press the
desired POSITION button 1 to 6 for which you
want to clear the settings.
Notes
• If you want to retain the previous pan and tilt
positions when the power is turned off and
turned on again, store those positions in
PRESET 1.
• Storing or clearing the settings in PRESET 1
takes about 2 seconds longer than for other
preset operations.
• When you are storing or clearing the settings in
one PRESET, you cannot restore, store or clear
the settings in another PRESET.
• For details on the items that can be cleared
from the memory, see “Items Stored in the
Preset” (page 47).
• You can register or delete the preset even while
the menu is being displayed. However, you
cannot perform the pan/tilt operation.
• Note that if you change the image flip setting,
the set preset will be cleared.
While holding
down
Press the
POSITION
button you
want to set.
While holding
down
Press the
POSITION
button you
want to clear.