Ad
minis
tra
ting t
he Camer
a
Setting the Action output — Action output Menu
32
Setting the Action
output
—
Action output
Menu
When you click
in the Administrator
menu, the Action output menu appears.
The Action output menu consists of the
Execution
Condition,
Mail Transfer, Alarm output
and
Edge
Storage
tabs.
Execution Condition Tab
Set execute conditions for each action.
Set the action input execute conditions when the
condition created in the Event condition tab is
implemented.
Mail Transfer:
Set the condition of mail transfer.
Alarm output 1:
Set the condition to control alarm
output of the I/O port on the rear of the camera.
Alarm output 2:
Set the condition to control alarm
output of the I/O port on the rear of the camera.
Edge Storage:
Set the condition to record images using
the Edge Storage function.
Mail Transfer Tab — Setting the e-
Mail (SMTP) Function
SMTP Server
Note
The frame rate and operability on the main viewer may
be reduced while a file is being transmitted by the e-Mail
(SMTP) function.
SMTP server name
Type the SMTP server name using up to 64 characters,
or the IP address of the SMTP server.
SMTP port number
Enter a port number from 25 to 65535.
The standard port number is 25.
Address
Recipient e-mail address 1, 2, 3
Type the recipient e-mail address using up to 64
characters.
You can specify up to three recipient e-mail addresses.
Administrator e-mail address
Type the Administrator e-mail address using up to 64
characters.
This address is used for reply e-mails and sending
system messages from the mail server.
Content
Subject
Type the subject/title of the e-mail using up to 64
characters.
An e-mail sent in response to alarm detection will
indicate the type of alarm in the subject.
(S1)
is added
for sensor input 1 detection,
(S2)
for sensor input 2
detection,
(TP)
for camera interference detection,
(MD)
is additionally available for motion detection.
Message
Type the text of the e-mail using up to 384 characters. (A
line break is equivalent to 2 characters.)
Event triggered execution
File attachment
Set whether an image file (JPEG file) is to be attached to
the e-mail or not.
When
On
is selected, the image file made using the
settings below is attached. When
Off
is selected, only
the message is sent.
Image file name
Type the file name you want to assign to the image to be
attached to an e-mail. You can use up to 10
alphanumeric characters, – (hyphen) and _ (underscore)
for naming.
Suffix
Select a suffix to be added to the file name.
None:
No suffix is added. The image file name is
assigned to the image to be sent via e-mail.
Date & time:
The date & time suffix is added to the
image file name.
The date/time suffix consists of lower two-digits of
the year (2 digits), month (2 digits), date (2 digits),
hour (2 digits), minute (2 digits), second (2 digits),
and sequential number (2 digits), thus adding 14-
digit number to the image file name.
Periodical execution
You can set to send e-mails periodically.
Image file name
Type the file name of the image attached to the e-mail
using up to 10 alphanumeric characters, – (hyphen) and
_ (under score).
Action output
Содержание SNC-VB600B
Страница 39: ...Sony Corporation ...
