Sony SNC-EMX30, Руководство пользователя

Страница: 78 / 275

Network camera Configuration | en 79
Sony Corporation User manual 2019-07 | V01 | DOC
– Continuous : the recording proceeds continuously. If the maximum recording capacity is
reached, older recordings are overwritten automatically.
– Pre-alarm : recording takes place in the pre-alarm time, during the alarm and during the
post-alarm time only.
– Off : no automatic recording takes place.
Stream
Select the stream to be used for standard recordings:
–
Stream 1
– Stream 2
– I-frames only
Alarm recording
Select a period for the Pre-alarm time from the list box.
Select a period for the Post-alarm time from the list box.
Alarm stream
Select the stream to be used for alarm recordings:
–
Stream 1
– Stream 2
– I-frames only
Check the encoding interval and bit rates from profile: box and select an encoder profile to
set the associated encoding interval for alarm recording.
Alarm triggers
Select the alarm type that is to trigger a recording:
–
( Only applicable to SNC-EMX cameras) Alarm input
– Analysis alarm
– Virtual alarm : select one of the sensors that are to trigger a recording, via RCP+
commands or alarm scripts, for example.
Export to account
Select an account from the drop-down box to export to an account. If an account has not yet
been defined, click
Configure accounts to jump to the Accounts page where the server
information can be entered.
Click
Set to apply the changes.
4.4.3 Maximum Retention Time
Recordings are overwritten when the retention time entered here has expired.
Enter the required retention time in days for each recording track.
Click
Set to apply the changes.
4.4.4 Recording Scheduler
The recording scheduler allows you to link the created recording profiles to the days and
times at which the camera's images are to be recorded. Schedules can be defined for
weekdays and for holidays.
Weekdays
Assign as many time periods (in 15-minute intervals) as needed for any day of the week. Move
the mouse cursor over the table - the time is displayed.
1.
Click the profile to be assigned in the Time periods box.
2. Click a field in the table and, while holding down the left mouse button, drag the cursor
across all of the fields to be assigned to the selected profile.
3. Click the No recordings profile in the Time periods box to deselect the intervals.