38
Recording TV programmes
To watch another TV programme while recording
To save a recording
To prevent accidental erasure, break off the safety
tab as illustrated. To record on the same tape
again, cover the tab hole with adhesive tape.
Tips
• To select a programme position, you can use the programme number buttons on the remote
commander. For two-digit numbers, press the –/– – (ten’s digit) button followed by the
programme number buttons.
• If you connect additional equipment to a LINE connector or jack, you can select the input
signal using the INPUT SELECT or
PROG +/– buttons.
• The
DISPLAY information appears on the TV screen indicating information about the
tape, but the information won’t be recorded on the tape.
• If you don’t want to watch TV while recording, you can turn off the TV.
Notes
• The
DISPLAY information does not appear during still (pause) mode or slow-motion
playback.
• The
DISPLAY information will not appear while playing an NTSC-recorded tape.
• If a tape has portions recorded in both PAL (MESECAM) and NTSC systems, the time
counter reading will not be correct. This discrepancy is due to the difference between the
counting cycles of the two video systems.
• When you insert a non-standard commercially available tape, the remaining time may not be
correct.
• The remaining time is intended for rough measurement only.
• About 30 seconds after the tape begins playback, the tape remaining time will be displayed.
• The station name*
1
may not appear if the VCR does not receive station name information
signals.
*
1
SLV-SE450K only
*
2
not available on SLV-SE100K/SX100K
1
Press
t
TV/VIDEO to turn off the VIDEO indicator in the display window.
2
Select another programme position on the TV.
Safety tab
