SEL18200 (E 18-200mm F3.5-6.3 OSS)
2-1
2. DISASSEMBLY
NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked or bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, do not pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, do not press down at wire of connector. It is possible that a wire is
snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
In case that the following notches or holes are located in the lens block, etc during disassembling/assembling the lens, use the universal wrench.
How to Use
SERVICE TOOLS
Attach the chip-A or chip-B to the universal wrench.
For the notches: chip-A
For the holes: chip-B
Match the universal wrench to the holes or notches of the lens block, etc.
Notches
Holes
Universal wrench
J-6082-609-A
Chip-A for
universal wrench:
J-6082-609-1
Chip-B for
universal wrench:
J-6082-609-2
Chip
Chip
Universal wrench
Match the universal wrench
to the width of holes or notches.
Chip-B
Chip-B
Holes
Notches
Chip-A
Chip-A
Cut and remove the part of gilt
which comes off at the point.
(Be careful that some
pieces of gilt may be left inside)
SG-310
Grease (SG-310):
9-913-200-37
