Sony SCD-XE800, Руководство по обслуживанию

Страница: 16 / 46

SCD-XE800
SCD-XE800
16 16
For Schematic Diagrams.
Note:
• All capacitors are in
µ
F unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in
Ω
and 1/4 W or less unless otherwise
specifi ed.
•
f
: internal component.
•
C
: panel designation.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
•
A
: B+ Line.
•
B
: B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : CD PLAY
*
: Impossible to measure
• Voltages are taken with VOM (Input impedance 10 M
!
).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: SA-CD PLAY
J
: CD PLAY (ANALOG)
c
: CD PLAY (DIGITAL)
For Printed Wiring Boards.
Note:
•
X
: Parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
f
: internal component.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
(Conductor Side)
Parts face side:
(Component Side)
Parts on the pattern face side seen
from the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
• MAIN board is multi-layer printed board.
However, the patterns of intermediate layers have not
been included in diagrams.
• Indication of transistor.
C
B
These are omitted.
E
Q
Note: The components identifi ed by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specifi ed.
POWER board
TRANS board
OUT-SW board
MOTOR board
KEY board
MAIN board
DISPLAY board
• Circuit Boards Location