Sony SAT-A1 - Digital Satellite System, Руководство по эксплуатации

Страница: 70 / 92

70
Chapter 6: Using the Installation Menu
Setting the Security Code
If the DSS receiver is accepting or receiving signals from another RF
remote control in your home (or from a neighbor’s house), you can
eliminate this problem by changing the security codes for the DSS
receiver and remote control.
Note
As an alternative, you can eliminate this problem by disabling the RF
capability of the DSS receiver, if you have no need for RF transmission. See
“Selecting IR/RF Transmission” on page 69 for details.
There are two steps to changing the RF security code: Step 1 is
changing the DSS receiver’s security code; step 2 is changing the DSS
remote control’s security code. Both the receiver and the remote control
must use the same three-digit security code.
Step 1: Select the DSS Receiver’s RF Security Code
1
Select SET UP REMOTE from the Installation Menu.
2
Select RF SECURITY CODE.
3
Select a different security code and then select OK.
4
Select OK from the Set Up Remote screen to save your changes and
return to the Installation Menu.
5
Go to “Step 2: Set the DSS Remote Control’s RF Security Code” on
page 71 to continue.
SET UP REMOTE
REMOTE SIGNAL
RF SECURITY CODE
RF ONLY
000
OK
CANCEL
IDENTIFY
HELP
The DSS receiver and remote control
are shipped with the RF security code
set to 000.
CODE 009
CODE 000 CODE 001 CODE 002 CODE 003
CODE 004 CODE 005 CODE 006 CODE 007
SET RF SECURITY CODE
OK
CANCEL
HELP
'
CODE 008 CODE 010
CODE 012 CODE 013 CODE 014 CODE 015
CODE 011