Sony RXD-700, Руководство по эксплуатации

Страница: 18 / 92

18 EN
Additional Information
You cannot tune in a frequency.
/ Adjust the position of the aerial.
/ Connect an external aerial for FM broadcasts.
/ Preset the stations again if you've moved.
There is severe hum and/or background noise.
/ Adjust the position or direction of the aerial.
/ Tune to a correct frequency.
/ Connect an external aerial for FM broadcasts.
/ Move the CD Receiver away from the source of
the noise.
RDS isn‘t working.
/ Make sure that you are tuned to an FM station.
/ Select a stronger FM station.
“No Preset” appears in the display.
/ If the mains lead is disconnected from the wall
outlet for more than one month, the memory is
erased. Preset stations again.
The station was interrupted by another station / This unit
automatically starts searching stations.
/ The EON function is working. Turn off EON
when you don't want the current programme
interrupted.
The appropriate display or information does not appear.
/ Contact the radio station and find out whether
or not they actually provide the service in
question. If so, the service may be temporarily
out of order.
The CD does not play.
/ There’s no CD inside this unit (“–NO DISC–”
appears in the display). Insert a CD.
/ Place the CD with the label side up on the disc
tray correctly.
/ Clean the CD (see page 17).
/ Moisture has condensed inside this unit.
Remove the disc and leave the CD Receiver
turned on for about an hour (see page 2).
If any problem persists, reset the CD Receiver
following the procedure on page 6.
Specifications
Amplifier section
Continuous RMS power output
55 + 55 watts
(4 ohms at 1 kHz, 0.7% THD)
Inputs
TAPE LINE IN (phono jacks):
sensitivity 150 mV, impedance 50
kilohms
Outputs
TAPE REC OUT (phono jacks)
:
150 mV, 4.7 kilohms
SPEAKER: accepts impedance of 4 to 16 ohms, 8
to 16 ohms (SPEAKER A + B).
CD player section
System Compact disc and digital audio system
Laser Semiconductor laser
(
λ
= 780 nm)
Emission duration: continuous
Laser output Max. 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up Block with 7 mm aperture.
Wavelength 780 – 790 nm
Frequency response 20 Hz – 20 kHz (±0.5 dB)
Signal-to-noise ratio More than 114 dB
Dynamic range More than 100 dB
Harmonic distortion Less than 0.003 %
Channel separation More than 108 dB (1 kHz, 20 kHz LPF)
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range 87.5 – 108.0 MHz
(50 kHz step)
Aerial FM wire aerial
Aerial terminals 75 ohm unbalanced
Intermediate frequency 10.7 MHz
Sensitivity at 26 dB quieting
(mono) 10.3 dBf, 0.9
µ
V/75 ohms
at 46 dB quieting
(stereo) 38.5 dBf, 23
µ
V/75 ohms
Usable sensitivity (IHF) 10.3 dBf, 0.9
µ
V/75 ohms
S/N at 40 kHz deviation
Mono: 75 dB
Stereo: 70 dB
Harmonic distortion
at 1 kHz
Mono: 0.04 %
Stereo: 0.07 %
Separation 45 dB at 1 kHz
Frequency response 30 Hz – 15 kHz (+0.3/–0.7)
AM tuner section
Tuning range 531 – 1,602 kHz
(9 kHz step)
Aerial AM loop aerial, External aerial
terminals
Intermediate frequency 450 kHz
Usable sensitivity 300
µ
V/m
S/N 50 dB (50 mV/m, 999 kHz)
Harmonic distortion 0.3 % (50 mV/m, 400 Hz)
General
Power requirements 230 V AC, 50/60 Hz
Power consumption 150 watts
Dimensions (w/h/d) Approx. 440
×
110
×
340 mm (17 3/8
×
4 3/8
×
13 1/2 in) incl. projecting parts
and controls
Mass Approx. 7.4 kg (16 lb 5 oz.)
Supplied accessories See page 4.
Design and specifications are subject to change without notice.