2. To fasten the remote control to your arm, wear it on the back of your hand as the “OK” illustration.
Then, thread the belt through
, facing the REC/ENTER button toward your fingertips, and the LCD
screen toward your elbow.
After attaching
, move
to cover the end of
.
Note
Attaching the belt incorrectly may cause injury.
When placing the remote control on your right arm, set the screen rotation in the remote control
settings to ON.
When using the remote control attached to your arm, always attach the supplied base plate and belt
correctly.
Be careful not to drop the remote control when unfastening the belt.
[6] How to use
Getting Started
Turning on/off the power of this unit
Turning on/off the power of this unit
Turn on/off the power of this unit.
1. Make sure that the connector cover of this unit is closed.
Securely close the connector cover until the yellow mark under the lock lever can no longer be
seen. If any foreign matter such as sand gets inside the connector cover, the sealing gasket may
be scratched, leading to water entering the remote control.