18
You can use a battery pack or AC power supply
from an AC adaptor.
For safety, use only the Sony battery packs and
AC adaptors listed below.
Lithium ion battery packs
BP-U30 (supplied)
BP-U60
BP-U60T
BP-U90
Battery chargers
BC-U1 (supplied)
BC-U2
AC adaptors (supplied)
MPA-AC1 (USA and Canada model only)
AC-NB12A (except USA and Canada model)
Do not store battery packs in locations exposed to
direct sunlight, flame, or high temperature.
Notes
• The camcorder cannot be powered from the BC-U1/
BC-U2 battery charger acting as an external power
source.
• When operating from a power outlet, use the supplied
AC adaptor.
• Always set the POWER switch to the Off position
before connecting a battery or AC adaptor. If it is
connected with the POWER switch in the On position,
the camcorder may be unable to start in some cases. If
the unit cannot be started, set the POWER switch to the
Off position and disconnect the battery pack or AC
adaptor temporarily, then wait about 30 seconds before
attempting to connect again. (If the AC adaptor is
connected while the camcorder is operating from the
battery pack, it can be connected with the POWER
switch in the On position without problem.)
To attach a battery pack, plug the battery pack
into the attachment
as far as it will go,
and then slide it down to lock it into position.
To remove a battery pack, press and hold the
BATT RELEASE button
, slide the
battery pack up and then pull it out of the
attachment.
Notes
• Before attaching a battery pack, charge the battery
using the dedicated BC-U1 or BC-U2 battery charger.
• Charging a battery immediately after use while it is
still warm may not fully recharge the battery.
Preparation
Power Supply
Caution
Using a Battery Pack
BATT RELEASE
button
Содержание PXW-FS7
Страница 128: ......