115
The following caution and operation messages may appear in the center of the screen. Follow the
instructions provided to resolve the issue.
1) “Media(B)” is displayed for the card in slot B.
Caution and Operation Messages
Display message
Cause and Solution
Battery Error
Please Change Battery
An error was detected in the battery pack.
Replace with a normal battery pack.
Backup Battery End
Please Change
The remaining capacity of the backup battery is insufficient.
Charge the backup battery.
Unknown Media (A)
1)
Please Change
A memory card that has been partitioned or a memory card containing
more clips that can be handled by the camcorder was inserted.
The card cannot be used in the camcorder, and must be replaced.
Cannot Use Media (A)
1)
Unsupported File System
A card using a different file system or an unformatted card was inserted.
The card cannot be used in the camcorder, and must be replaced or
formatted using the camcorder.
Media Error
Media (A)
1)
Needs to be Restored
An error occurred on the memory card, and the card must be restored.
Restore the memory card.
Media Error
Cannot Record to Media (A)
1)
The memory card may be damaged, and can no longer be used for
recording.
Playback is possible, so making a copy and replacing the memory card is
recommended.
Media Error
Cannot Use Media (A)
1)
The memory card may be damaged, and can no longer be used for
recording or playback.
The card cannot be used in the camcorder, and must be replaced.
Media (A)
1)
Error
Recording Halted
Playback Halted
Recording and playback was stopped because an error occurred while
using the memory card.
If the problem persists, replace the memory card.
Media Reached Rewriting Limit
Change Media (A)
1)
The memory card has reached the end of its life.
Make a backup, and replace the card immediately. If you continue using
the card, the card may not be able to record or play.
For details, refer to the operating instructions for the memory card.
Fan Stopped
The built-in fan stopped.
Avoid use at high temperatures, disconnect the power, and contact your
Sony service representative.
Invalid setting value was reset:
Media/Clip Naming/Camera Position
Please save All File again
The Clip Naming format setting was reset because an invalid ALL file
was loaded.
Configure the desired format settings, and try to save the ALL file again.
Содержание PXW-FS7
Страница 128: ......