54
Setting auto ND filter
1
Set the PRESET/VARIABLE
switch
B
to VARIABLE, and
switch the ND FILTER dial
A
to
position 1, 2, or 3.
The ND filter mode is set to variable
mode.
2
Set
(CAMERA/PAINT)
t
[ND
FILTER]
t
[AUTO ND FILTER] to
ON in the menu.
(auto) appears on the icon indicating
the ND filter value.
b
Notes
• Switching the auto ND filter on/off is supported
in variable mode only.
• When the camcorder is in preset mode or when
the ND FILTER dial
A
is set to CLEAR, the
auto ND filter is disabled.
• When full auto mode is on in variable mode, the
density of the ND filter is adjusted
automatically, even if the auto ND filter is off.
z
Tips
• You can assign the auto ND filter ON/OFF
setting to an ASSIGN button.
• Can be operated using Direct Menu.
However, when full auto mode is on, operating
the ND filter using the ASSIGN button or Direct
menu is not supported.
• Zebra 1: Set a reference level and range
for zebra display.
• Zebra 2: Display zebra above a set level.
Setting zebra
Select
(DISPLAY SET)
t
[ZEBRA]
in the menu, and set the following items.
*1 Zebra 1 level (reference level)
*2 Zebra 1 range
*3 Zebra 2 level (minimum level)
When ZEBRA1 or ZEBRA2 is selected, the
icon or
icon appears.
b
Notes
• Zebra 1 and zebra 2 cannot be displayed at the
same time.
• Zebra is not recorded onto the memory card.
• When [ZEBRA SELECT] is OFF, the zebra
point of the histogram is not displayed.
z
Tip
• You can assign [ZEBRA] to an ASSIGN button.
The setting switches to OFF
t
ZEBRA1
t
ZEBRA2 each time you press the button.
* On the PXW-FS5, this function is supported
using Ver. 2.0 or later (see page 5).
Zebra 1 / Zebra 2
* On the PXW-FS5, this function is supported
using Ver. 2.0 or later (see page 5).
Item
Settings (default
setting in bold)
[ZEBRA SELECT]
OFF
, ZEBRA1,
ZEBRA2
[ZEBRA1 LEVEL]
*1
0% to 109% (1%
increments) (
70%
)
[ZEBRA1
APERTURE
LEVEL]
*2
2% to 20% (2%
increments) (
10%
)
[ZEBRA2 LEVEL]
*3
0% to 109% (1%
increments) (
100%
)
Adjusting the brightness (continued)
