Sony PMW-300, Руководство по обслуживанию

Страница: 83 / 134

2-20. Prism Block Assembly
Preparation
1. Remove the bottom panel assembly. (Refer to “2-5. Bottom Panel Assembly” )
2. Remove the inside panel assembly. (Refer to “2-6-1. Inside Panel Assembly” )
3. Remove the outside panel assembly. (Refer to “2-7-1. Outside Panel Assembly” )
4. Remove the rear panel assembly. (Refer to “2-8. Rear Panel Assembly” )
5. Remove the handle assembly. (Refer to “2-11-1. Handle Assembly” )
6. Remove the IO block. (Refer to “2-10. IO Block” )
7. Remove the DCP-64 board. (Refer to “2-14. DCP-64 Board” )
8. Remove the front lens assembly. (Refer to “2-15. Front Lens Assembly” )
9. Remove the lens unit. (Refer to “2-19. Lens Unit” )
Procedure
1. Disconnect the three harnesses from the three connectors (CN100, CN101, and CN102) on the SE-1139 board.
2. Release the three harnesses and the three fine-wire coaxial cables from the three claws.
Claws
CN101
Harnesses
CN100
CN102
SE-1139 board Fine-wire coaxial cables
Fine-wire coaxial cable
Harness
PMW-300
2-55