Sony PlayStation Portable PSP-1004, Инструкция по эксплуатации, Страница: 15 / 148

15
Precautions
Overseas use
When travelling note any applicable wireless regulations.
Moisture condensation
If the PSP
®
system or UMD™ is brought directly from a cold location to a
warm one, moisture may condense on the lens inside the system or on the
UMD™. Should this occur, the system may not operate properly. In this case,
remove the UMD™ and turn off and unplug the system. Do not put the UMD™
back in until the moisture evaporates (this may take several hours). If the
system still does not operate properly, contact the appropriate PSP
®
customer
service helpline which can be found within every PSP
®
format software
manual.
UMD™ handling
• Do not touch the opening on the rear of the disc (recorded surface of the disc)
with your fingers.
• Do not allow dust, sand, foreign objects or other types of dirt to get on the
disc.
• If the UMD™ becomes dirty, gently wipe the exterior and recorded surfaces
of the UMD™ using a soft cloth. Do not use solvents or other chemicals.
• Do not use a UMD™ that is cracked or warped or has been repaired. The
UMD™ may break inside the PSP
®
system, leading to injury or malfunction.
Cleaning
For safety reasons, unplug the AC Power Cord from the electrical outlet and
remove the Battery Pack from the system before cleaning.
x
Cleaning the exterior surface excluding LCD screen
Wipe gently with a soft cloth. Do not use solvents or other chemicals to clean
the exterior of the PSP
®
system.
x Cleaning the LCD screen
Wipe gently with a soft cloth.
x Cleaning the connectors
• Do not use when the connectors of the system, AC Adaptor or the AC Power
Cord are not clean. Remove the dirt with a dry cloth. If used when dirty, the
flow of electrical current may be obstructed.
• If the Headphones or Remote Control connectors become dirty, this could
cause noise or interruptions in sound. Wipe the connectors with a dry, soft
cloth to keep in a clean condition.