54
Playback
C
h
ap
te
r 4
R
e
c
o
rd
in
g,
P
lay
ba
c
k
an
d
C
o
p
y
1
Press the SHTL/JOG button or VAR/JOG button,
turning it on.
When the SHTL/JOG or VAR/JOG button is pressed
during recording, recording stops and the unit enters
jog mode. If you do not want to stop recording, set
setup menu item 145 MODE KEY ENABLE
DURING RECORDING to “stop”.
2
Turn the jog dial in the desired direction, at the speed
corresponding to the desired playback speed.
Playback in jog mode starts.
The Jog/shuttle transport indicators light as follows.
b
(green):
Lights during playback in the reverse
direction.
B
(green):
Lights during playback in the forward
direction.
3
To stop playback in jog mode, stop turning the jog dial.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to “dial direct”
(factory default setting), you can start jog playback by
simply rotating the jog dial, even when the SHTL/JOG
and VAR/JOG buttons are not lit.
Playback in shuttle mode
In shuttle mode, you can control the speed of playback by
the angular position of the shuttle dial. The range of
playback speed is ±20 times normal speed or maximum
speed.
To carry out playback in shuttle mode, proceed as follows.
1
Press the SHTL/JOG button, turning it on.
When the SHTL/JOG button is pressed during
recording, recording stops and the unit enters shuttle
mode. If you do not want to stop recording, set setup
menu item 145 MODE KEY ENABLE DURING
RECORDING to “stop”.
2
Turn the shuttle dial to the desired angle
corresponding to the desired playback speed.
Playback in shuttle mode starts.
The shuttle dial has a detent at the center position, for
still image playback.
The Jog/shuttle transport indicators light as follows.
b
(green):
Lights during playback in the reverse
direction.
B
(green):
Lights during playback in the forward
direction.
x
(red):
Lights during still image display.
3
To stop playback in shuttle mode, return the shuttle
dial to the center position, or press the STOP button.
When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to “dial direct”
(factory default setting), you can start shuttle playback
by simply rotating the shuttle dial, even when the
SHTL/JOG button is not lit.
• When setup menu item 101 SELECTION FOR
SEARCH DIAL ENABLE is set to “dial direct”, after
using the shuttle dial, return it to the center position. If
the shuttle dial is not in the center position, it is possible
occasionally for vibration from other operations to
activate the dial, and start playback in shuttle mode.
• If you switch to shuttle mode and operate the shuttle dial
during playback, the initial shuttle playback speed will
skip one step.
For example, if the shuttle dial is in the center position
during playback, the shuttle playback will start at 1.0
times normal speed, not at 0.5 times normal speed.
To alternate between normal-speed playback and
shuttle mode playback
Set the shuttle dial to the position corresponding to the
desired shuttle playback speed, then press the PLAY and
SHTL/JOG buttons alternately.
Playback in variable mode
In variable mode, you can control the speed of playback in
the range of –2 to +2 times normal speed by the angular
position of the shuttle dial.
For playback of XAVC-format clips in variable mode, you
can control the speed of playback in the range –1 to +2
times normal speed.
To carry out playback in variable mode, proceed as
follows.
Jog/shuttle
transport indicators
Notes