Sony PDW-1, Руководство по эксплуатации

Страница: 17 / 56

17 2-1 Front Panel
C
h
ap
te
r 2
N
a
m
e
s
a
n
d
F
u
nc
tion
s
of
P
a
rt
s
The indicator may flash or light only for
five seconds depending on the alarm.
You can check alarms generated by this unit, using
the alarm log of the utility software (see page 44).
If the indicator is flashing four times a second, and
it is not possible to check the alarm log, a
malfunction may have occurred. In this case, contact
your Sony service representative.
When the error is eliminated, the indicator
goes off.
c
ACCESS indicator
Lights when the disc is being accessed by a
computer. If the
~ / 1 (on/standby) switch is
set to the
1
position while this indicator is
lit, access to the disc is completed before
the unit switches to the standby state.
While the ACCESS indicator is lit, do not
turn off the AC power switch, disconnect
the power cord, or remove the battery. This
could lead to a loss of data from the disc.
d
~ / 1 (on/standby) switch and
indicator
When the AC power switch on the rear
panel is in the
~ position, or a battery is
loaded, this switches the PDW-D1 between
the operating (
~ ) and standby ( 1 ) states.
When the switch is moved to the ~ position,
the indicator lights. When the switch is
moved to the
1
position, the indicator goes
off.
When operating the PDW-D1 from an AC
power supply, normally leave the AC
power switch in the
~ position, and switch
the PDW-D1 between the operating and
standby states using the
~
/
1
(on/standby)
switch.
When the DISC IN indicator is lit or
flashing, and the FILE ACCESS MODE
indicator is lit, setting this switch to
1
position has no effect on the power supply.
Eject a disc before carrying out the
operation.
e
Manual eject mechanism
When there is no power supply to the unit,
to eject the disc, remove the cover and
rubber cap over this part, then turn the
screw counterclockwise with a Phillips
screwdriver.
For details, see 3-5-6 “To Eject Discs With the Unit
Powered Off” (page 27).
f
DISC IN indicator
Lights when a disc is loaded.
It flashes while the disc is being inserted,
and while it is being ejected.
g
EJECT button
Ejects a disc (see page 27) .
h
Disc slot
With the label surface on the right, insert
the disc
(see page 27) .
i
Battery adaptor attachment section
To use a battery pack, remove the Phillips
screws, and fit the optional BKP-L551
battery adaptor.
For details, see “To attach a battery pack” (page
24).
Note
Note
Note