213
Starting a Videoconference Using SIP
C
hap
te
r 9
: Vi
de
oco
n
fe
re
n
c
e U
s
in
g SI
P
Operations are the same as those for a point-to-point conference.
For details, see “Receiving a Call from a Remote Party” on page 94.
You can put a call on hold during a point-to-point or multipoint
videoconference when connected by SIP.
To put a call on hold during a point-to-point videoconference
1
Press the CONNECT/DISCONNECT (
/
) button on the Remote
Commander during communication.
The following submenu appears.
2
Select “Hold” using the
V
,
v
,
B
or
b
button and the PUSH ENTER button
on the Remote Commander.
The “On Hold (SIP)” display appears on the monitor screens of the local and
remote sites.
• Dialing and answering a call are not available during a point-to-point
videoconference.
• If a call in a point-to-point videoconference is held during transmission or
reception of the data via the Data Solution Box or the White Board, the
transmission or reception is cancelled and will not be restored after the hold mode
is cancelled.
To cancel the hold mode of a point-to-point videoconference
You can cancel the hold mode only when you have operated the system to
enter the hold mode.
Press the CONNECT/DISCONNECT (
/
) button on the Remote
Commander while in the hold mode, select “Resume Call” from the submenu
and press the PUSH ENTER button. The hold mode is cancelled and you can
continue the conference.
Receiving a Call from a Remote Party
Putting a Call on Hold
Notes
Hold
Disconnect
Transfer
Cancel
Phone Book
Dial
Содержание PCS-1 - Video Conferencing Kit
Страница 284: ...Sony Corporation ...