NWZ-S763/S763BT/S764/S764BT/S765
8
2-3. OPEN THE SHORT-LAND
Note 1:
This illustration sees the mechanical commonness block from LCD assy side (lower half).
Note 2:
Make sure to remove one solder to become an open state before disassembling the mechanical commonness block.
Note 3:
Solder the short-land after all wirings are connected when you exchanged some mounted board.
2-4. CAP
1
Remove the solder of short-land.
1
screw
(M1.4
u
2.5)
2
Push the part
A
.
A
3
Move the panel (rear) assy in the
direction of the arrow
B
a little.
4
Remove the claw after moving the
cap in the direction of the arrow
C
.
4
Remove the claw after moving the
cap in the direction of the arrow
C
.
B
C
1
screw
(M1.4
u
2.5)
5
cap
– Front bottom view –
Note:
When installing the cap, take
care not to crush two claws.
