Sony MZ-N707 OpenMG Jukebox NOTES on installing & operating, Руководство по эксплуатации

Страница: 43 / 240

43
-GB
Editing recorded tracks
You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
•
You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 61).
• If you perform an editing operation while
playing, editing results will not be recorded
until you stop the recorder and “TOC Edit”
disappears in the display.
• Do not move the recorder while “TOC Edit”*
is flashing in the display.
•
The lid does not open until “TOC Edit”
disappears in the display after editing.
• When group mode is on, editing can be
performed only for the tracks registered into
the selected group.
∗
TOC = Table of Contents
Labeling/relabeling
recordings
You can name tracks, groups and discs
using the recorder’s character palette.
Available characters
•
Capital and small letters of the English
alphabet
•
Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)
Numbers of characters you
can input
Track, group, or disc name: Approx. 200
each
Numbers of characters you
can input in a disc
Numbers/marks: Approx. 1,700
Notes
• “NAME FULL” appears when you try to enter
more than 1,700 characters on a disc. Enter a
shorter name for the track, group, or disc, or
set the “LP Stamp” setting to “Stamp OFF”
when recording in MDLP mode so that “LP:”
is not be added at the beginning of the track
name (page 26).
• When labeling a disc which has been recorded
using the group function, make sure group
mode is on in order to prevent the group
management information from being
overwritten by mistake.
• If you enter the symbol “//” between the
characters in disc names such as “abc//def”,
you may be unable to use the group function.
T MARK
MENU
VOL +/–
END SEARCH
GROUP/
CANCEL
ENTER/ . /
> / x /
X
DISPLAY
PLAY MODE
X
x
Control