64
-GB
Messages
If the following messages flash in the display window, check the messages below.
Error message Meaning/Remedy
BLANK
• An MD with no recording on it is inserted.
BUSY
• You tried to operate the recorder while it was accessing the recorded
data.
,
Wait until the message goes out (in rare cases, it may take a few
minutes).
Saving
• The MD player is recording information (sounds) from the memory
to the disc.
,
Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
ERROR
• Recording was not correctly done.
,
Place the recorder at a place with no vibrations and record again.
• The disc is soiled with an oil film or finger prints, is scratched, or is
not a standard disc.
,
Try recording again with another disc.
• The recorder cannot read the disc information correctly.
,
Reinsert the disc.
• The recorder cannot read the disc information correctly.
,
Insert another disc.
,
If it is no problem to erase the entire disc, do so (page 46).
FULL
• The remaining recording time on the disc is 12 seconds (stereo), 24
seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.
,
Replace the disc.
HiDCin
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
,
Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD
• The recorder is locked.
,
Slide HOLD against the arrow to unlock the recorder (page 16,
49).
LoBATT
• Battery is weak.
,
Replace the dry battery (page 15).
MEMORY
• You tried to record with the recorder placed where it receives
continuous vibration.
,
Put the recorder on a stable place, and start recording again.
Содержание MZ-N1
