Sony MVS-8000X SystemMVS-7000X System, Руководство пользователя

Страница: 110 / 706

USO
RESTRITO
110
Executing a Transition
Ch
a
p
te
r 3
S
ig
n
a
l S
e
le
c
ti
o
n
and
T
ra
n
s
itio
n
s
Combinations of Auto and Manual
Transitions
Using the [AUTO TRANS] button, the [CUT] button, and
the fader lever, use the following procedures.
Moving the fader lever during an auto
transition
During an auto transition started by pressing the [AUTO
TRANS] button, operating the fader lever immediately
enables the fader lever, and the [AUTO TRANS] button
goes off. Thereafter, the fader lever controls the progress
of the transition.
Executing an auto transition after partly
moving the fader lever
•
Press the [CUT] button to instantaneously complete the
transition.
•
Press the [AUTO TRANS] button to complete the rest of
the transition at the preset transition rate.
If the transition rate is set to 100 frames, and the fader lever
has moved through
1
/
4
of the transition, then the remaining
3
/
4
of the transition is carried out in 100 frames.
Once the fader lever
is moved to this
position, the non-sync
state ends, and the
next transition
(direction shown by
the arrow) is possible.
Manual transition completed
as auto transition when
moving the fader lever upward:
Top two LEDs light.
Non-Sync State
If the fader lever is in an intermediate position when a
transition is completed as an auto transition, then the lever
position no longer agrees with the transition state. This is
termed a non-sync state.
In a non-sync state, two lit LEDs indicate the position from
which a normal transition can be carried out. This is either
at one end position or both end positions of the fader lever
travel.
Moving the fader lever toward the position of the lit LEDs
does not carry out a transition, but when the fader lever
reaches the end position the non-sync state is released, and
it is now possible to carry out the next transition.
Manual transition completed
as auto transition when
moving the fader lever
downward: Bottom two LEDs
light.
•
If the fader lever is moved in the direction away from the
lit LEDs, this carries out the next transition, over the
remaining part of the fader lever travel.
•
Even in a non-sync state, you can carry out an auto
transition by pressing the [AUTO TRANS] button.
During the auto transition, the indicators show the
transition progress in the usual way, but when the
transition completes, they once again indicate the non-
sync state.
Fader Lever Operation in Bus Fixed
Mode
Flip-flop mode and bus fixed mode
The following describes the difference between flip-flop
mode and bus fixed mode, taking an M/E bank as an
example; the functionality is the same, however, on the
PGM/PST bank.