Sony MVS-8000X SystemMVS-7000X System, Руководство пользователя

Страница: 109 / 706

USO
RESTRITO
Executing a Transition
109
Knob Parameter Adjustment Setting values
1 Transition
Rate Independent
transition rate 0 to 999
(frames)
Ch
a
p
te
r 3
S
ig
n
a
l S
e
le
c
ti
o
n
and
T
ra
n
s
itio
n
s
Depending on the way in which the transition was
executed, the action will be as follows.
•
When you press the [CUT] button, the pattern limit
is immediately released, and the image switches
instantaneously.
•
When you press the [AUTO TRANS] button, until
the state of the next transition, the transition is
carried out over the duration given by the transition
rate.
•
When you move the fader lever, the transition is
carried out from the pattern limit state to the state
before the pattern limit transition was carried out.
Moving the fader lever even a little synchronizes the
fader lever position with the transition state, and you
can move the fader lever either in the forward
direction or in the reverse direction.
Depending on the Setup settings, the transition may be
executed at the instant you press the [PTN LIMIT]
button, and the button goes off. In this case, execution
continues for the time specified by the dedicated
transition rate in the menu setting, as far as the state of
the next transition.
For details of the setting, see “Selecting the Bank to
Make the Settings” in Chapter 20 (Volume 2).
To set the transition rate when the pattern limit is
released
1
In the <Pattern Limit Release> group of the Edge/
Direction menu, select one of the following.
Auto Trans Rate: Use the transition rate set in the
transition rate control block
Independ Trans Rate: Independent transition rate
2
If you selected “Independ Trans Rate” in step 1 , adjust
the following parameter.
Fader lever
CUT button
AUTO TRANS button
Transition control block (standard type)
To execute a transition on the M/E or PGM/PST bank by a
button operation, use the following procedure in the
transition control block.
To carry out an instantaneous cut transition: Press the
[CUT] button.
To carry out a gradual transition: Press the [AUTO
TRANS] button.
This executes the transition at the preset transition rate
(see page 105).
While the transition is executing, the [AUTO TRANS]
button lights amber. When it completes the button
goes off.
To complete a partially executed transition
instantaneously: Press the [CUT] button.
The [AUTO TRANS] button goes off.
Executing a Transition With the
Fader Lever (Manual Transition)
Executing an Auto Transition
The following two modes can be used for auto transition.
Cut
A cut switches instantaneously from the current video to
the new video. When the next transition is a key transition,
the key cuts in or out instantaneously.
Auto transition
The transition from the current video to the new video is
carried out automatically at a constant rate, using the
transition effect selected as the transition type.
You can set the transition rate in advance
(see page 105) .
Using the fader lever, you can manually control the
progress of the transition. Moving the fader lever from one
end of its travel to the other completes the transition.
To execute a manual transition with the transition control
block fader lever, use the following procedure.
To carry out the transition completely: Move the lever
over the full range of its travel.
To pause a partly executed transition: Stop moving the
fader lever.
To resume a paused transition: Resume moving the
fader lever.