Sony MVS-6000, Руководство пользователя

Страница: 61 / 400

61
Names and Functions of Parts of the Control Panel
Chap
te
r
2
Men
u
s
and Con
tro
l
P
a
nel
direction, and counterclockwise for the
reverse direction.
When the resizer control mode is enabled
By turning the ring, you can zoom the key
to which the resizer is applied, and change
the aspect ratio.
When the [LOC SIZE] or [LOC XYZ]
button is held down, the Z-ring operation is
switched to a finer control. (fine mode)
When the VTR/disk recorder/frame
memory operation mode is enabled
Turning the Z-ring controls the tape
transport/disk drive/frame memory clip
operations, at a speed determined by the
operating buttons. Turn clockwise for the
normal direction, and counterclockwise for
the reverse direction.
e
MENU button
Press this button, turning it on, to enable
adjusting the parameters allocated to the
knobs in the menu using the trackball and
Z-ring.
In the case of the DME menu, the operation
applies to the selected DME channel.
In VTR/disk recorder/frame memory
operation mode, press this button, setting it
to On, to make it possible to carry out
timeline start/stop point setting operation
for the device selected with the device
selection buttons (timeline setting mode).
Device Control Block (MKS-8036A Search Dial Module,
Option)
Using the device control block (MKS-
8036A search dial module
1)
, option), you
can directly operate an XDCAM, disk
recorder, VTR or other external device,
frame memory clip, or shotbox. The device
control block (MKS-8031TB track ball
module, option) can be used together.
1) The product name of the MKS-8036A is “device
control module,” but in this manual it is referred to
as “search dial module” to distinguish it from the
MKS-8031TB trackball module.