223
Cross-Point Settings
Chapt
er 17
Cont
ro
l P
anel Se
tup
The functions of the buttons in the memory recall
section during effect editing are on two pages; to set
the functions of buttons on the second page, press the
[2] button in the <PageSelect> group in the button
area.
•
Buttons in the memory recall section during
macro editing
5
Press [Set] to confirm the setting.
To cancel an assignment
Select the corresponding button, then press [Clear].
To return all button assignments to the factory
default state
Press [Default].
Cross-Point Settings
Creating Cross-Point Assign Tables
As cross-point assign tables, you can create a “main” table
and up to 14 other tables (table 1 to table 14). However,
you can only carry out assignment of the video and key
combinations in the main table.
Creating the main table
In the main table, a pair consisting of a video signal and a
key signal is assigned to each button number. You can also
assign the same signal to another button number at the
same time. Further, you can delete currently assigned
signals from the main table.
1
In the Engineering Setup >Panel >Xpt Assign menu
(7322) or Engineering Setup >Panel >Xpt Assign
>Table Button Assign menu (7322.1), press [Main, V/
K Pair Assign].
The Main, V/K Pair Assign menu (7322.5) appears.
The left of the status area shows the video and key
signal names, and source number currently assigned in
the main table. On the right is a list of the source
numbers and signals that can be assigned. When the
shift button is pressed, the number column is
distinguished by color.
2
Select the button number.
3
When assigning a video signal, press [Video] in the
<Assign> group. When assigning a key signal, press
[Key]. (You can select a video signal and a key signal
at the same time.)
[Video] and [Key] in the <Assign> group cannot be
turned off at the same time. One or the other is always
on.
4
Select the signal.
“IN33” to “IN48” and signal names relating to DME
and M/E-2 are disabled, even if selected.
5
Using the buttons in the <Xpt Assign> group, assign
the selected signal to the button number currently
selected in the main table.
Copy
COPY
Paste
PSTE
Select all
ALL
Insert
INS
Modify
MOD
Delete
DEL
Keyframe loop count setting
KF LOOP
Effect duration setting
EFF DUR
Keyframe duration setting
KF DUR
Delay setting
DLY
Constant duration mode on or off
CNST DUR
Go to specified timecode
GOTO TC
Go to specified keyframe
GOTO KF
Set range
FROM TO
Return the button display to that
before effect was executed
EXIT
Switch to numeric keypad input
mode
STOR
Go to first keyframe
REWIND
Switch to shifted functions
SHFT
Go to previous keyframe
<<PREV
Go to next keyframe
>>NEXT
Execute effect
RUN
Function
Button indication
Undo
UNDO
Pause setting
PAUS
Auto insert mode on or off
AUTO INS
Copy
COPY
Paste
PSTE
Select all
ALL
Insert
INS
Modify
MOD
Delete
DEL
Set range
FROM TO
Go to specified event
GOTO EVNT
Function
Button indication
Notes
