Chapter 2
Location and Function of Parts
2-20
Chapter 2
Location and Function of Parts
2-2 Connector Panel
7
External device connectors
1
REMOTE 2 PARALLEL I/O(50P) connector
(D-sub 50-pin)
Connect remote control signals from an external
device.
For details, refer to the Installation Manual.
2
CONTROL PANEL connector (round type, 10-
pin)
In addition to the lower control panel, a similar control
panel can be connected to this unit. To connect such a
second control panel, use this connector. When two
control panels are connected, use the PANEL SELECT
switch on the switch panel
(see page 2-16)
to specify
which control panel will control this unit.
3
VIDEO CONTROL connector (D-sub 15-pin)
For remote control of the internal digital video
processor, connect an optional BVR-50/50P Remote
Control Unit.
Always power off this unit before connecting the
remote control unit.
4
OPTION connector (D-sub 9-pin)
Not used.
5
REMOTE 1-IN(9P) connector (D-sub 9-pin)
When using this unit together with another MSW-
2000-series recorder or a D-1, D-2, or Betacam VTR,
and a BVE-series BVE-900/910/2000/9000/9000P/
9100/9100P or other editor, connect the optional 9-pin
remote control cable from the other unit to this
connector.
Depending on the setting of setup menu item 211, you
can use this connector alone, or in a loop-through
configuration with the REMOTE 1-OUT(9P)
connector.
6
REMOTE 1-OUT(9P) connector (D-sub 9-pin)
This provides the loop-through output for remote
control signals from the REMOTE 1-IN(9P)
connector.
Depending on the setting of setup menu item 211, you
can use this connector alone, or in a loop-through
configuration with the REMOTE 1-IN(9P) connector.
7
RS-232C connector (D-sub 9-pin)
Use this for monitoring and diagnosis of the state of
this unit from an external computer, using ISR
(Interactive Status Reporting).
8
Time code input/output section
1
TIME CODE IN connector (XLR 3-pin, female)
To record time code from an external device, input a
time code signal from the time code output connector
of the other device.
2
TIME CODE OUT connector (XLR 3-pin, male)
This outputs a time code according to the operating
state of the unit, as follows:
• During playback: the playback time code
By setting setup menu item 606, you can also output
the time code from the internal time code generator
locked to the playback time code.
• During recording: the time code generated by the
internal time code generator or the time code input to
the TIME CODE IN connector.
TIME CODE
IN
OUT
1
TIME CODE IN connector
2
TIME CODE OUT connector
REMOTE 1-IN(9P)
CONTROL PANEL
REMOTE 2 PARALLEL I/O(50P)
VIDEO CONTROL
REMOTE 1-OUT(9P)
RS232C
(OPTION)
1
REMOTE 2 PARALLEL
I/O(50P) connector
2
CONTROL PANEL
connector
3
VIDEO CONTROL
connector
4
OPTION connector
5
REMOTE 1-IN(9P)
connector
6
REMOTE 1-OUT(9P)
connector
7
RS-232C connector