USO
RESTRITO
378
Source Patch
Ch
a
p
te
r 23
Us
e
r S
e
tu
p
User Setup
Chapter
23
Source Patch
The source patch is a function whereby signal pairs
recorded in applicable data are automatically converted to
use key snapshots, snapshots, and keyframes in different
switcher systems as is.
Sequence of Source Patch
Operations
In the following description, two different switcher
systems are referred to as Switcher A and Switcher B.
In Switcher A, assign a name (user source name) to each
signal pair.
r
Export the user source name file to a removable disk.
r
In Switcher B, import the user source names from a
removable disk.
r
Create a signal pairs conversion correspondence table
(patch table).
r
In Switcher B, recall the snapshot, key snapshot, or
keyframe file created in Switcher A (signal pairs are
replaced according to the patch table).
2
Select the target pair in the list on the left.
3
Press [Usr Src Name] outside the list.
4
Enter a name of not more than 16 characters, and press
[Enter].
5
Repeat steps
2
to
4
, to set all of the necessary names.
6
Press [File >Exp Usr Src Name].
The Exp Usr Src Name menu (7116) appears.
7
Select the removable disk as the destination, and press
[
t
Export].
To apply the signal pairs in the patch table to this
menu
Press [Apply Patch Tbl].
Exporting a User Source Name File
to a Removable Disk
In Switcher A, use the following procedure.
1
Open the User Setup >Source Patch >User Source
Name menu (7211).
Creating a Patch Table (Conversion
Table)
Load the removable disk prepared in Switcher A to
Switcher B, and use the following procedure in Switcher
B.
1
Open the User Setup >Source Patch >Patch Table
menu (7212).
