USO
RESTRITO
Applying Special Effects (Nonlinear Effect Settings)
191
No.
Parameter
Adjustment
5
Slant
Slant of waves
No.
Parameter
Adjustment
1
Amp V
Amplitude of waves in vertical
direction
2
Freq V
Frequency of waves in vertical
direction
3
Offset V
a)
Vertical direction in which to
offset wave phase and amount of
movement
4
Speed V
b)
Vertical direction and speed of
waves
5
Slant
Slant of waves
No.
Parameter
Adjustment
1
Amp H
Amplitude of waves
2
Freq H
Frequency of waves
3
Offset H
a)
Direction in which to offset wave
phase and amount of movement
4
Speed H
b)
Direction and speed of waves
5
Slant
Slant of waves
No.
Parameter
Adjustment
1
Amp H
Amplitude of waves in horizontal
direction
2
Freq H
Frequency of waves in horizontal
direction
3
Offset H
a)
Horizontal direction in which to
offset wave phase and amount of
movement
4
Speed H
b)
Horizontal direction and speed of
waves
Ch
a
p
te
r 10
DM
E
O
p
e
ra
ti
o
n
s
To turn an effect off
In the setting menu, press the button for the effect name,
turning it off, or press [OFF] in the lower right part of the
screen in the Non Linear menu.
Parameter group [1/2]
Wave Settings
There are two modes: H&V and Size. You can set the size
and frequency of the waves, the wave form, the amount of
wave movement, and the range. In H&V mode, you can
also set the wave angle.
Applying the Wave effect
1
In the <Mode> group of the Non Linear >Wave menu
(4141.1), select the wave modulation mode.
H&V:
Modulate vertically and horizontally without
changing the size of the image. This mode allows
waves to be created in both the vertical and
horizontal directions at the same time.
Size:
Create waves by reducing and expanding the
image. This mode allows waves to be created in
one direction only.
Parameter group [2/2]
a)
Set when Lock is on.
b)
Set when Lock is off.
When Size is selected
Size not modulated.
1
and
2
are the same
size.
a)
Set when Lock is on.
b)
Set when Lock is off.
Offset
Before modulation
Create waves by reducing
1
and expanding
2
.
Amp
2
Set the following parameters, according to the selected
mode.
When H&V is selected
Parameter group [1/2]
To stop the waves
Press [Lock], turning it on.
With each press, the waves alternately stop and start
moving again.
To select the waveform
Press [Form] and set the following parameters.
When H&V mode is selected
No.
Parameter
Adjustment
1
Form H
Waveform in horizontal direction
2
Form V
Waveform in vertical direction
