MHC-GZR5D.GB.3-296-435-11(1)
110
GB
To prevent a tape from being
accidentally recorded over
Break off the cassette’s overwrite protection tab
from side A or B as illustrated.
Break off
the cassette
tab
To later reuse the tape for recording, cover the
broken tab with adhesive tape.
About a tape longer than 0 minutes
The use of the tape with more than 90 minutes
of play time is not recommended except for
long, continuous recording or playback.
Cleaning the tape heads
Use dry- or wet-type cleaning cassette
(available separately) after every 10 hours of
use, before you start an important recording,
or after playing an old tape. Failure to clean the
tape heads can cause degraded sound quality or
an inability of the unit to record or play tapes.
For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Use a demagnetizing cassette (available
separately) after every 20 to 30 hours of use.
Failure to demagnetize the tape heads can
cause an increase in noise, a loss of high
frequency sound, and an inability to completely
erase tapes. For details, refer to the instructions
of the demagnetizing cassette.
Specifications
Main unit
Amplifier section
The following measured at AC 230 V,
50/60 Hz (European and Russian models)
The following measured at AC 127, 240 V,
50/60 Hz (Saudi Arabian model)
The following measured at AC 120, 220,
240 V, 50/60 Hz (Other models)
Power output (rated):
72 W + 72 W (6 Ω at 1 kHz, 1%
THD)
RMS output power (reference):
120 W + 120 W (per channel at 6 Ω,
1 kHz, 10% THD)
Inputs
AUDIO IN (stereo mini jack):
voltage 700 mV, impedance
47 kilohms
MIC (phone jack):
sensitivity 2 mV, impedance
10 kilohms
Outputs
VIDEO OUT (phono jack):
max. output level 1 Vp-p, unbalanced,
Sync negative, load impedance
75 ohms
DVD DIGITAL OUT (Square optical
connector jack, rear panel):
Wavelength 650 nm
PHONES (stereo mini jack):
accepts headphones of 8 ohms or
more