Sony MHC-GN1100D, Руководство по эксплуатации, Страница: 65 / 96

65 GB
Oth
e
r Op
er
atio
ns
7
Press "/1 to turn off the system.
Other operations
Notes
• If you use the Play Timer or Recording Timer
and the Sleep Timer at the same time, the
Sleep Timer has priority.
• The Play Timer and Recording Timer will not
be activated if the system is turned on or if
“STANDBY” flashes in the display.
• The system turns on 30 seconds before the
preset time. Do not operate the system from
the time the system turns on until the
recording starts.
• The volume is reduced to minimum during
Recording Timer.
Changing the display
1
Press AMP MENU repeatedly to
select the item you want.
The last selected item setting appears
in the display.
SPECTRUM
Change the spectrum analyzer display.
DIMMER
Adjust the brightness of the front panel
display.
2
Turn OPERATION DIAL to select
the setting you want.
3
Press ENTER.
— Power Saving Mode
The demonstration display and the clock
display can be turned off to minimize the
amount of power consumed during
standby mode (Power Saving Mode).
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
1)
t No display (Power
Saving Mode)
t
Clock
2)
t
Demonstration t …
1)
The display changes and the indicators flash
even when the system is turned off.
2)
The clock display automatically turns to
Power Saving Mode after 8 seconds.
Note
You cannot perform the following operations
during Power Saving Mode:
– Setting the clock (page 22).
– Changing the AM tuning interval (page 53).
– Turning on the system by pressing DVD,
TUNER/BAND, TAPE A/B, TV/SAT or
VIDEO on the unit.
– Changing the color system (page 19).
To Do this
Check the setting
1
Press TIMER MENU.
“TIMER SELECT?”
flashes in the display.
2
Press ENTER.
3
Press
V
or
v
repeatedly to select
“PLAY SELECT?” or
“REC SELECT?”, then
press ENTER.
Change the
setting Start from step 1.
Cancel the Play
Timer or
Recording Timer
1
Press TIMER MENU.
“TIMER SELECT?”
flashes in the display.
2
Press ENTER.
3
Press
V
or
v
repeatedly to select
“TIMER OFF?”, then
press ENTER.
Turning off the display