8
Hooking up the system (continued)
4
Press ENTER.
5
Press
v
or
V
repeatedly to set the hour.
6
Press
B
.
The minute indication flashes.
7
Press
v
or
V
repeatedly to set the
minute.
8
Press ENTER.
Tip
If you made a mistake or want to change the time,
start over from step 1.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
Saving the power in
standby mode
Press DISPLAY repeatedly when the
system is off. Each time you press the
button, the system switches cyclically as
follows:
Demonstration
t
Clock
t
Power Saving
Mode
Tips
•
?/1
indicator lights up even in the Power Saving
Mode.
• The timer functions in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the
demonstration or twice to show the clock
display.
When carrying this system
Perform the following procedure to protect the
CD mechanism.
1
Make sure that all discs are removed from
the unit.
2
Hold down CD and then press
?/1
until
“STANDBY” appears.
When you release the buttons, “LOCK”
appears.
3
Unplug the AC power cord.
Inserting two R6 (size AA)
batteries into the remote
E
e
e
E
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates the
system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.
Setting the time
1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
Proceed to step 5 when “CLOCK” appears
in the display.
3
Press
v
or
V
repeatedly to select “SET
CLOCK”.
