Sony MG40 Series, Справочник по командам

Страница: 94 / 140

4-6
(E)
MG40 Series

Preset
Th is function is used to set numerical values in the measurement values.
Note
• In the wait to go past reference point status, a mode error results, and values can neither be set nor
called.
• Values can neither be set nor called for an axis in the error status.
Set
Ethernet CC-Link
Measurement
mode
The command sets the numerical values in the current values.
Command format
PSS Designated axis =<Value>
<Value> Corresponds to output resolution (Factory setting: Zero)
Return format Execution results
Target Designated axis, MG42 hub unit, all axes
Save setting values Setting values saved.
Examples of use Transmission :
PSS[01B]=123.2315
(Set axis B for the MG42 hub unit ID01 to 123.2315.)
Return : OK000 (Successfully completed.)
Compatible command Designated axis P=<Value>
Acquire
Ethernet CC-Link
Measurement
mode
The command acquires the preset values.
Command format
PSS Designated axis ?
Return format PSS Designated axis =<Value>
<Value> Corresponds to output resolution
Target Designated axis
Examples of use Transmission :
PSS[00A]?
(Acquire the preset value of axis A for the MG41 main unit.)
Return : PSS[00A]=100.0000 (Th e preset value is 100.0000.)
Compatible command None
Call
Ethernet CC-Link
Measurement
mode
The command calls the preset values.
Command format
PSR Designated axis
Return format Execution results
Target Designated axis, MG42 hub unit, all axes
Examples of use Transmission :
PSR[

]
(Call the preset values for all the axes.)
Return : OK000 (Successfully completed.)
Compatibility command Designated axis RCL