Sony MG40 Series, Справочник по командам

Страница: 137 / 140

(E)
6-1
MG40 Series
6. Error Codes
6-1. Overview of Error Codes
Error codes are expressed in a hexadecimal 2-digit format (0x00 to 0xFF).
Th
e higher digits express the general classifi cation, and the lower digits express the details.
Classifi cation Description
Numbers in the 00’s General information
Numbers in the 10’s Command-related errors
Numbers in the 20’s Ethernet communication-related errors
Numbers in the 30’s CC-Link communication-related errors
Numbers in the A0’s to D0’s Hardware-related errors
6-2. Table of Error Codes
Numbers in the 00’s: General information, additional information
00 No errors/no additional information (Normally used when there are no errors.)
Numbers in the 10’s: Command-related errors
10 Command error Th ere is no command or the command has illegal syntax.
12 Mode error Th e mode does not permit the execution of the command in
question.
13 Target not available Th e target designated as the command target is not connected to
the system or the wrong method was used to designate it (such as
in cases where all the axes were designated with a command for
which all the axes cannot be designated).
14 Parameter error Th e parameter does not exist or the wrong method was used to
designate it.
Numbers in the 20’s: Ethernet communication-related errors
20 Network Setting Error Th ere is a problem in the network settings.
21 Connection Error (Command
Interface) Connection with the command interface has failed.
22 Connection Error (Data Interface) Connection with the data interface has failed.
Numbers in the 30’s: CC-Link communication-related errors
30 Setting Error One or more station number setting switches or transmission
speed setting switches have been set outside the range of
specifi cations.
31 Communication Error Communication has timed out.
A disconnected cable, broken cable or equipment failure may be
to blame.