36
FR
Quand le véhicule est dépourvu de position
ACC
Après avoir fait correspondre correctement les
raccordements et les câbles d’alimentation
commutés, raccordez l’appareil à l’alimentation du
véhicule. Si vous avez des questions et des
problèmes de raccordement de cet appareil, qui ne
sont pas abordés dans ce mode d’emploi,
contactez votre concessionnaire automobile.
Pour pouvoir capter votre voix lors d’un appel en
mode mains libres, vous devez installez le micro
.
Attention
Il est extrêmement dangereux de laisser le cordon
s’enrouler autour de la colonne de direction ou du
levier de vitesses. Assurez-vous de placer le
cordon et les autres pièces de manière à ce qu’ils
ne gênent pas la conduite.
Si des airbags ou d’autres équipements destinés
à absorber les chocs sont installés dans votre
véhicule, contactez le magasin où vous avez
acheté cet appareil ou le concessionnaire
automobile avant de procéder à l’installation.
Remarque
Avant de fixer l’adhésif double face
, nettoyez la
surface du tableau de bord avec un chiffon sec.
1
Pour activer la télécommande filaire,
réglez [STR CONTROL] sous [SET
STEERING] sur [PRESET] (page 20).
Installation
Avant d’installer l’appareil, retirez son tour de
protection
et son support
.
1
Pincez les deux bords du tour de
protection
, puis retirez-le.
2
Insérez les deux clés de déblocage
jusqu’à ce qu’elles émettent un déclic,
enfoncez le support
, puis dégagez
l’appareil en le tirant vers le haut.
Installation du micro
Rouge
Rouge
Jaune
Jaune
Clip (non fourni)
Utilisation de la télécommande filaire
Retrait du tour de protection et du
support
Dirigez le crochet vers l’intérieur.
Содержание MEX-N6002BD
Страница 35: ......