![background image](http://html.mh-extra.com/html/sony/mex-bt3100u/mex-bt3100u_operating-instructions-manual_1329896007.webp)
7
Canceling the DEMO
mode
You can cancel the demonstration display
which appears while this unit is turned off.
1
Press
, rotate the control dial
until “DISPLAY” appears, then press
it.
2
Rotate the control dial until “DEMO”
appears, then press it.
3
Rotate the control dial to select
“DEMO-OFF,” then press it.
The setting is complete.
4
Press
(BACK) to return to the
previous display.
The display returns to normal reception/
play mode.
Setting the clock
The clock uses a 24-hour digital indication.
1
Press
, rotate the control dial
until “GENERAL” appears, then press
it.
2
Rotate the control dial until “CLOCK-
ADJ” appears, then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
+/–.
4
After setting the minute, press
.
The setup is complete and the clock
starts.
To display the clock, press
.
Detaching the front panel
You can detach the front panel of this unit
to prevent theft.
1
Press and hold
.
The unit is turned off.
2
Press the front panel release button
,
then remove the panel by pulling it
towards you.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Note
Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a
parked car or on a dashboard/rear tray.
Attaching the front panel
Engage part
of the front panel with part
of the unit, as illustrated, and push the
left side into position until it clicks.