000
60
Chapter 7: Settings
Configuring the Network Settings for Streaming Transmission
To perform streaming transmissions, configure the settings for connecting the unit to the external
network.
When Connecting to a Network via DHCP
DHCP is configured by default. Generally, you do not need to configure settings to use DHCP.
When Manually Configuring the IP Address and Other Settings
Use the PC UI to configure the network settings for streaming transmission.
[Tips]
ˎ
ˎ
The unit supports only IPv4 network environments.
ˎ
ˎ
You cannot change the network while streaming transmission is in progress.
1
Select [Network] in the [Setup] screen of the PC UI.
2
Select [Manual] for [Mode] to enable manual configuration of the settings, and enter the IP address,
subnet mask, default gateway, and DNS server addresses.
3
Select [Set].
[Tips]
PGM outputs from the HDMI output connector will stop
during the few seconds before settings are applied after
selecting [Set].
When the settings are successfully applied, a
messages appears.
4
Select [OK].
Resetting Network Settings and
Streaming Settings
You can reset the network and streaming settings
by selecting [Network Reset] in the [Setup] screen,
and then selecting [Reset].
[Tips]
ˎ
ˎ
Ustream account settings configured on the unit will also
be deleted.
ˎ
ˎ
PGM outputs from the HDMI output connector will
stop during the few seconds before the reset process is
completed after selecting [Reset].
