Sony MCC-1000MD, Инструкция по эксплуатации

Страница: 53 / 61

53
You can shoot 3D images by using two units
connected as described below.
To connect two units, use a commercially-
available 75
Ω
coaxial cable.
Recommended cable: 5CFB, length of 1 m (3.3 ft)
or less
1
Using a commercially-available 75
Ω
coaxial cable, connect the first unit’s
3D-SYNC OUT connector on the CCU
to the second unit’s 3D-SYNC IN
connector on the CCU.
2
Set the video format and image quality
settings so that they match on both
units.
Notes
• When adjusting the installation of two camera
heads, be sure to keep 3D standards in mind so
as not to adversely effect human subjects.
• Use camera cables of equal length for both of
the cameras.
You can lock button and knob operations on the
front panel of the CCU by pressing the
LOCK
button on the front panel. The LOCK button
lights while operations are locked. When a button
or knob other than the
1 (on/standby) switch or
LOCK button is operated while operations are
locked, the LOCK button blinks and a warning
message is displayed on the connected video
monitor.
Note
Operations for the 1 (on/standby) switch and
LOCK button will not be locked.
Releasing the lock
Press the LOCK button again.
Using Two Cameras to
Shoot 3D Images
Unit 1
Unit 2
Locking CCU Operations
LOCK button