Sony LMD-941W, Руководство по эксплуатации

Страница: 67 / 76

Adjustment Using the Menus
67
FOCUS SETTING
FUNCTION BUTTON SETTING
About the function assigned to the
function button
SCAN
Press the button to change the scan size of the picture.
With every press of the button, the picture switches in
the sequence NORMAL scan
t
OVER scan
t
NATIVE (see “Scan mode image” on page 68).
ASPECT
Press the button to set the aspect ratio of the picture, 4:3
or 16:9.
BLUE ONLY
Press the button to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
“chroma” and “phase” adjustments and observation of
signal noise.
MONO
Press the button to display a monochrome picture. When
the buttons is pressed again, the monitor switches
automatically to color mode.
MARKER
Press the button to display the marker. Set the aspect
marker in the MARKER SETTING menu (see page 63).
H/V DELAY
Press the button to observe the horizontal and vertical
sync signals at the same time.
CLOSED CAP.
Press the button to display the closed caption. Set the
closed caption setting in the CLOSED CAPTION
SETTING menu (see page 69).
WFM/ALM/VS (WFM/ALM/VECTOR)
Press the button to display the WFM/ALM/vectorscope
display. Set the WFM/ALM/vectorscope display setting
in the WFM/ALM/VECTOR SETTING menu (see
page 65).
TARGET Select 75 or 100. Switches the
vectorscope target between 75% and
100%.
Submenu Setting
FOCUS MODE Switches the focus mode.
•
STD : An image with sharpened edges
is displayed.
• COLOR : Displays the intensified
areas of images with color
selected in COLOR below.
• OFF: FOCUS MODE is deactivated.
COLOR Selects the displayed intensified color
from white (W), red (R), green (G), blue
(B), and yellow (YL).
FREQUENCY Sets the center frequency of the edge
sharpening signal.
You can select from L, M, MH, H.
RANGE Sets the amount by which the level of
edge sharpening may vary.
You can set from 1 to 3.
GAIN Sets the level of edge sharpening.
You can select from 0 to 100.
Submenu Setting
F O C U S M O D E :
xxx
C O L O R :
xx
F R E Q U E N C Y:
x
R A N G E :
x
G A I N :
x
USER CONFIG – FOCUS SETTING
F 1 B U T T O N : xxxx
F 2 B U T T O N : xxxx
F 3 B U T T O N : xxxx
F 4 B U T T O N : xxxx
F 5 B U T T O N : xxxx
F 6 B U T T O N : xxxx
F 7 B U T T O N : xxxx
USER CONFIG – FUNCTION BUTTON SETTING
Submenu Setting
F1 BUTTON to F7
BUTTON Assigns the function to the function
buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE, etc.
Factory setting
• F1 button : BRIGHTNESS
• F2 button : CONTRAST
• F3 button : CHROMA
• F4 button : SCAN
• F5 button : H/V DELAY
• F6 button : VOLUME
• F7 button : I/P MODE