100
Ot
her
I
n
fo
General
Problem
Possible Remedies
How to reset TV to
factory settings
s
Turn off the main power of the TV set. While holding down
RESET
on the
remote control, turn on the main power of the TV set. Turn on the TV. While
holding down
RESET
on the remote control, press
POWER
on the media
receiver unit. (The TV will turn itself off, then back on again.) Release
RESET
.
How to restore Video settings
to factory settings
s
Press
RESET
on the remote control while in the Video Menu (see page 78).
How to restore Audio settings
to factory settings
s
Press
RESET
on the remote control while in the Audio Menu (see page 80).
Cannot cycle through the other
video equipment connected to
the TV
s
Be sure the
Video Label
option is not set to
Skip
(see page 90).
Cannot operate Menu
s
If a menu option appears in gray, this indicates that the menu option is not
available.
Lost password
s
In the password screen (see page 86), enter the following master password:
4357
.
The master password clears your previous password; it cannot be used to
temporarily unblock channels.
LED on the display unit is lit
s
The POWER ON/STAND BY LED (see page 16) lights up when the TV is turned
on. If the LED blinks continuously, this may indicate the TV needs a service.
s
The TIMER LED (see page 16) indicates that the timer is set. When the timer is
set, this LED will remain lit even when the TV is turned off.
