Ad
mi
ni
st
ra
ti
n
g
th
e Ca
mer
a
Sending an Image via E-mail — e-Mail (SMTP) Menu
50
Sending an Image via E-
mail
— e-Mail (SMTP) Menu
When you click
SMTP
in the Administrator menu, the
e-Mail (SMTP) menu appears.
Using e-Mail (SMTP) function, you can send an e-mail
with attached image that has been shot linked with an
external sensor input or with the built-in object detection
function. The image file can also be sent periodically.
The e-Mail (SMTP) menu consists of three tabs:
Common
,
Alarm sending
and
Periodical sending
.
Common Tab — Setting the e-Mail
(SMTP) Function
e-Mail (SMTP)
Select
On
when you use the e-Mail (SMTP) function.
Notes
• You cannot send an audio file by using the e-mail
sending function.
• The frame rate and operability on the main viewer
may be reduced while a file is being transmitted by the
e-Mail (SMTP) function.
SMTP server name
Type the SMTP server name using up to 64 characters,
or the IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
mail.
Off:
Select if no authentication is required when an e-
mail is sent.
On:
Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the
POP server
name
,
User name
and
Password
as required.
SMTP:
Select when SMTP authentication is
required.
POP before SMTP:
Select when POP before SMTP
authentication is required.
Note
When you set
Authentication
to
On
, be sure to select
either or both
SMTP
or/and
POP before SMTP
.
POP server name
It is necessary when
POP before SMTP
is selected for
Authentication
.
Type the POP (receiving mail) server name using up to
64 characters, or type the IP address of the POP server.
This setting is necessary when the SMTP server that
sends e-mails performs authentication using the POP
user account.
User name, Password
Type the user name and password of the user who owns
the mail account using up to 64 characters. This setting
is necessary when the SMTP server that sends e-mails
performs authentication.
Recipient e-mail address
Type the recipient e-mail address using up to 64
characters.
You can specify up to three recipient e-mail addresses.
Administrator e-mail address
Type the Administrator e-mail address using up to 64
characters.
This address is used for reply e-mails and sending
system messages from the mail server.
Subject
Type the subject/title of the e-mail using up to 64
characters.
When
Alarm sending
of the Alarm sending tab is set to
On
, an e-mail sent in response to the alarm detection
will indicate the type of alarm in the subject.
S1
is added
for sensor input 1 detection,
S2
is added for sensor input
2 detection,
MD
is added for moving object detection
and
UD
is added for unattended object detection.
Message
Type the text of the e-mail using up to 384 characters. (A
line break is equivalent to 2 characters.)
OK/Cancel
