A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network setting Menu
45
Obtain an IP address automatically
(DHCP)
DHCP server is installed on the network. Select it when
the IP address is assigned by DHCP server. IP address is
assigned automatically.
Note
When you set
Obtain an IP address automatically
(DHCP)
, make sure that DHCP server is working on the
network.
Use the following IP address
Select this when a fixed IP address is set.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when
Obtain an IP
address automatically (DHCP)
is selected.
Note
When you select
Obtain DNS server address
automatically
, make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
Host name
Type the wireless network host name of the camera to be
transmitted to the DHCP server. This setting is valid
only when
Obtain an IP address automatically
(DHCP)
is selected in the Wireless tab.
Domain suffix
Type the wireless network domain suffix of the camera
to be transmitted to the DHCP server. This setting is
valid only when
Obtain an IP address automatically
(DHCP)
is selected in the Wireless tab.
Note
The domain suffix is sent to the DHCP server as FQDN
(Fully Qualified Domain Suffix) information when
Host
name
is set.
Type
Select the network connection type
Ad hoc mode
or
Infrastructure mode
. Select
Ad hoc mode
when
connecting to the computer directly, or select
Infrastructure mode
when connecting to the computer
via an access point or a radio router. When you select
Ad
hoc mode
, specify the wireless channel.
Note
The setting of the HTTP port number is common to the
setting of the network cable.
Antenna
When you use dedicated wireless card SNCA-CFW1
(optional) or the wireless LAN antenna SNCA-AN1
(optional) that can be connected to SNCA-CFW1, you
can select one of the following antenna settings.
Internal:
The built-in antenna within SNCA-CFW1 is
used for transmission. Suitable for a short-range
sending and receiving because it is non-directional.
External:
Select it when you need a long-range sending
and receiving with connecting SNCA-AN1 to
SNCA-CFW1.
Diversity:
Select it when you need both a short-range
and a long-range sending and receiving at the same
time while SNCA-AN1 is connected to SNCA-
CFW1.
The high sensitive antenna is selected.
Notes
• When you remove the wireless LAN card, be sure to
first turn off the power of the camera.
• When you use a wireless LAN card, the throughput of
communication data through the Ethernet may
decrease.
SSID
Type the service set ID to identify the wireless network
you want to access using up to 32 ASCII characters
(alphanumeric).
For your security, be sure to change the factory setting.
