Sony Ipela PCS-XC1, Руководство по эксплуатации

Страница: 23 / 190

23
Turning the Unit On/Off
C
h
apt
er
1:
In
st
al
la
tio
n
and
Pr
e
par
at
io
n
• When you turn on the power of the unit for the first time after installation, the setup
wizard will appear after the self-diagnosis is completed. Set up your system following
the wizard.
For setups using the wizard, see “Setting Up the System Immediately after
the Installation – Initial Setup Wizard” on page 26.
• You can check the version of the unit, optional dedicated equipment connected, and
the application software installed using the Machine Status menu.
For details on the Machine Status menu, see page 64.
To save power, the unit will enter standby mode if you do not operate it for a
specified period of time. When the unit is in standby mode, the POWER
indicator blinks slowly (about once every 5 sec.).
You can turn on the unit with any button on the Remote Commander if the unit
is in standby mode.
Once the unit receives a call, the standby mode is automatically released.
1
Display the Home menu on the monitor screen, then press the @ / 1 button
on the Remote Commander.
The message “Power off?” appears on the monitor screen.
2
Press the
V
,
v
,
B
or
b
button on the Remote Commander to select OK, then
press the ENTER button.
Alternatively, you can press the
@
/
1
button on the Remote Commander.
The unit enters standby mode, and the POWER indicator blinks slowly
(about once every 5 sec.).
To cancel setting the unit to standby
Select “Cancel” with the
V
,
v
,
B
or
b
button on the Remote Commander, then
press the ENTER button in step 2 above.
To release the standby mode
Press any button on the Remote Commander.
To specify the standby time
Specify the time that you want the unit to remain on before entering into
standby mode (1 to 99 minutes) by setting “Standby Time” of the Device Setup
page of the General setup menu. If you do not want the unit to enter the standby
mode, set “Standby Mode” to “Off”.
For the settings, see “Standby Time” and “Standby Mode” in the General
setup menu on page 54.
Standby Mode Function
Setting the Unit to Standby Mode