202
Starting a Videoconference Using SIP
For details on the Split mode and the Voice Activate mode, see “What is
“Broadcast Mode”?” on page 175 of Chapter 7.
• Only “Disconnect” and “Resume Call” are available in the hold mode.
• When all the receiving terminals enter the hold mode in a multipoint videoconference
during transmission or reception of the data via the Data Solution Box or reception of
the White Board image, the transmission or reception is cancelled and will not be
restored after the hold mode is cancelled. If a connected terminal puts a call on hold
but communication with other terminal(s) remains established, however, transmission
or reception via the Data Solution Box or reception of the White Board image is not
cancelled.
You can transfer a call to another remote party during a point-to-point
videoconference when connected by SIP.
Call transfer is not possible during a multipoint videoconference.
1
Press the CONNECT/DISCONNECT (
/
) button on the Remote
Commander during communication.
The following submenu appears.
2
Select “Transfer” using the
V
,
v
,
B
or
b
button and the ENTER button on
the Remote Commander.
The remote terminal in communication enters the hold mode. The hold mode
continues until the call transfer is completed.
Notes
Transferring a Call
Note
Cancel
Phone Book
Detailed Dial
Disconnect
Hold
Transfer
Bob
John
2
3
4
5
6
1
OSAKA
NEW YORK
Содержание Ipela PCS-TL50
Страница 283: ...Sony Corporation ...