Sony Ipela NSR-1100, Руководство по установке

Страница: 26 / 336

Step 3: Settings
26
Caution
• If schedule recording and alarm recording settings
already exist when you execute “automatic record,”
the automatic configurations replace the previous
settings.
• If the camera storage locations are deliberately
changed, you can perform basic configuration again to
recalculate the other settings. The settings will not be
recalculated automatically.
Settings that Require Individual
Configuration
Further configuration is required in the following cases.
Storage location settings
Under basic configuration settings, data is stored on the
first partition of the unit’s internal hard disk.
For details on recording data to an optional NSRE-S200
unit or to other partitions, refer to the User’s Guide
(PDF).
When constructing systems that include
multiple NSR units or RealShot Manager
Advanced servers
When configuring multiple servers, individual
configuration is required. For details, refer to the User’s
Guide (PDF).
Pan, tilt, and zoom settings for analog cameras
Configure pan, tilt, and zoom settings for analog
cameras as follows from the [Control] tab of Device
Configuration.
1
Select the analog camera.
2
Select a protocol based on the analog camera’s
settings.
3
Enter the control number configured on the selected
analog camera.
Note
To configure these settings, you must configure the
transmission mode in the “Serial Port” settings of the
Setup Wizard beforehand.
Audio settings for cameras
Under basic configuration settings, audio is disabled.
For details on enabling audio, refer to the User’s Guide
(PDF).
Configurations for Using RealShot
Manager Advanced Client Software
Configure the following settings on the NSR unit that
will act as the master server. For details on the settings,
refer to the User’s Guide (PDF).
1
Configure the following settings in the Server
Configuration screen of the Administration Menu.
1
Select [Master] under [Central Server Mode].
2
Select the network interface for connection in
[Network Interface for Remote Client
Connection] under [Connect from Remote
Client].
1 2 3
2 1